The 10 X 12 Palette/Panel Holder will adjust from an angle of 100 degrees to 180 degrees (completely flat) when fully opened. The tripod fitting that is located on the underside of the palette is the same that is found on the bottom of a camera. The 10 X 12 Palette/Panel Holder has a sliding support arm on the right side of the palette. The arms on the panel holding surface that will stretch to hold the panel in place will extend from 5 inches to 17 1/2 inches horizontal. Included is one Side Palette Extension that can be attached to either the left or right side of the outer palette.
The Palette/Panel Holder is made of solid Black Walnut (the outside edges of the device) and Baltic Birch plywood (the palette mixing area and panel holding surface). The wood is glued and nailed together by hand and then sanded and treated in Danish Oil (natural color) prior to final assembly. All of the sliding hardware (including the spring arm mechanism) is handmade and then assembled to the final product at our shop.
The Palette/Panel Holder is made of solid Black Walnut (the outside edges of the device) and Baltic Birch plywood (the palette mixing area and panel holding surface). The wood is glued and nailed together by hand and then sanded and treated in Danish Oil (natural color) prior to final assembly. All of the sliding hardware (including the spring arm mechanism) is handmade and then assembled to the final product at our shop.