12 X 16 Palette/Panel Holder
SKU:
495
$252.00
$252.00
per item
The 12X16 Palette/Panel Holder is unique compared to our smaller sizes because it offers a removable center ledge that will support the weight of larger panels or stretch canvas up to 1 inch thick.
The palette depth on the 12X16 Palette/Panel Holder is 7/8 inch deep. This is 1/4 inch deeper than our smaller sizes.
There is also a latch on the front of the 12X16 size that is not included on our smaller sizes of Palette/Panel Holders.
The palette depth on the 12X16 Palette/Panel Holder is 7/8 inch deep. This is 1/4 inch deeper than our smaller sizes.
There is also a latch on the front of the 12X16 size that is not included on our smaller sizes of Palette/Panel Holders.
- Overall Dimensions: 18" X 12 3/4" X 2 1/2"
- Palette Work Area: 17 1/8" X 12" X 7/8"
- Panel Capacity: Anywhere from 5" out to 24" horizontally, no vertical limitation
- Palette Extension: 12 3/4" X 6 3/4"
- Weight: Approx 4 lb
2 available
The 12 X 16 Palette/Panel Holder will adjust from an angle of 100 degrees to 170 degrees when fully opened. The tripod fitting that is located on the underside of the palette is the same that is found on the bottom of a camera. The 12 X 16 Palette/Panel Holder has a sliding support arm on each side of the palette. The arms on the panel holding surface that will stretch to hold the panel in place will extend from 5 inches to 24 inches horizontal. Included is one Side Palette Extension that can be attached to either the left or right side of the outer palette.
The Palette/Panel Holder is made of solid Black Walnut (the outside edges of the device) and Baltic Birch plywood (the palette mixing area and panel holding surface). The wood is glued and nailed together by hand and then sanded and treated in Danish Oil (natural color) prior to final assembly. All of the sliding hardware (including the spring arm mechanism) is handmade and then assembled to the final product at our shop.
The Palette/Panel Holder is made of solid Black Walnut (the outside edges of the device) and Baltic Birch plywood (the palette mixing area and panel holding surface). The wood is glued and nailed together by hand and then sanded and treated in Danish Oil (natural color) prior to final assembly. All of the sliding hardware (including the spring arm mechanism) is handmade and then assembled to the final product at our shop.